Annovi Reverberi RSV2.5G25D-F25 Pressure Washer Pump

Features

• RSV2.5G25D-F25 series are designed to direct drive on gasoline engines ranging from 5 – 13 h.p. Intended use for medium to heavy tasks; this triplex plunger pump features the latest in design and technology.
• Life tested over 500 hours at maximum performance of 4 gpm at 4,000 psi.
• The RSV2.5G25D-F25 series features a compact and efficient intergraded unloader valve and fixed chemical injector.
• The RSV2.5G25D-F25 is a result of our combined 60 years of pumps building experience and expertise.
• Manifold: New high efficiency design concept. (Patented). Forged brass for strength and no porposity for long life and higher hydrostatic pressures.
• Plungers: Ceramic coated stainless steel.
• Crankcase: Precision die-cast, cooling fins and anodized for maximum heat dissipation.
• Bearings: Oversized for maximum life and load disbursement, needle bearing on the drive side and ball on the non-drive side. Each bearing is held in position on the crankshaft and crankcase by snap rings. This assures positive alignment and centering of the connecting rods and crankshaft in relation to the crankcase, it also eliminates the crankshaft from floating.
• Valves, Seats, and Springs: Stainless steel with specially designed Ultra FormTM cages to provide long life and positive seating.
• Seals and V-Packings: “V” style (D-1) Buna-N (cotton duct weave base) strong and tightens under load.
• Oil Seals: All are constructed of Buna-N rubber.
• Plunger Rods: Stainless steel construction for strength (no plating to scrape off), o-ring plunger sealing system.
• Connecting Rods: One piece special alloy aluminum and bronze based, oversized for maximum strength, load disbursement, and life. Heavy pin area construction, for added load strength.